Jaguar-XJ6 - 1994 XJ6 Runability Prob
Jim (12.218.156.159) - Sat Sep 27 16:36:55 2008
My 94 XJ6 has been die'n and not restarting. I have replaced the cps and the ign ampl and fuel pump. I can jump the power at the O2 sensor heater relay and the car will run. I need to know where the "high power board" is as described in the elect diag in order to prove out my grounds there. Any info you may have about this type of problem would GREATLY be appreciated.Thx Jim
Reply #1 tom (207.144.24.5) - Fri Jan 23 21:02:56 2009
I had a similar problem with my 94 xj6 after I got water in my gas tank. Before I found the water, I replaced the ignition module (with aluminum base under it). Then came the dying thing and not restarting for a while. Turned out that I didn't have the aluminum plate bolted down tight that the ign. module sets on and was loosing my ground. Make sure the fit is tight on the plug and that no sparks are occuring close to those little wires from the plug. Check it at night so you can see the sparks, thats how I found mine. I love my Jag.
| |